Support Our Sponsors! Click On Their Banner To Visit Their Site!


Moderators: HotRodAl
Go
New
Find
Notify
Tools
Reply
  
QL pressure data for .223 reduced loads Login/Join 



posted
PPU brass, CCI 400 primer, Titegroup, Hornady 2230 (45gr Hornet SP), 2.115 COL (.004 off lands), 1:12 twist I believe.

Looking for data up to about 36k psi. Send to me via email please. Thanks. I already have full power data with other powders on hand.

This message has been edited. Last edited by: Hersh5317,


Formerly Redleg11B
 
Posts: 151 | Location: PA | Registered: January 21, 2014Reply With QuoteReport This Post



posted Hide Post
James Calhoon has some data you seek for “cat sneeze” loads.


---------------------------------
G whiz, it's a Contender or a G2, never was G1!
 
Posts: 2826 | Location: Kansas U.S of A | Registered: November 01, 2003Reply With QuoteReport This Post



posted Hide Post
I saw his Blue Dot info. I have none, but have TG so was just wondering if anybody was willing to get me some reference data. I have seen Hodgdon's data already and was curious how much velocity I could get before getting above about 32k psi to be safe.


Formerly Redleg11B
 
Posts: 151 | Location: PA | Registered: January 21, 2014Reply With QuoteReport This Post
  Powered by Social Strata  
 


© Specialty Pistols 2003 - 2019 All Rights Reserved.
All Material Contained Here Is Protected And May NOT Be Reproduced,
Copied or Distributed, in any form, Without Written Permission.
"Specialty Pistols", "Specialty Pistols Bulletin Board" and
"Specialty Pistol Gear" are Trademarks of
Accurate Arms & Ammo, LLC.