Support Our Sponsors! Click On Their Banner To Visit Their Site!

Moderators: Cisco
Model 94 Angle Eject. Login/Join 

I've had this 94 for only about 10 years.In that time I shot a couple of deer for our freezer.I originally equipped it with a Williams peep sight which worked quite well until my eyes started to change.I then installed this Leupold Var-X III 2.5-8 power in Warne steel rings.I also put a recoil pad simply because I've always found these carbines a little too short for me.I installed Uncle Mikes swing swivel studs in the butt and on the magazine tube.

Anyway here it is.A Winchester 94 Angle eject pre-crossbolt safety with a laminate stock.

Posts: 66 | Location: US | Registered: January 12, 2012Reply With QuoteReport This Post


Picture of Duffy
posted Hide Post
Very Nice 94. I really like the looks of that wood and 2X on the pad for added length.


A body at rest stays at rest, until the wife shows up.
Posts: 4603 | Location: Odessa Wa. | Registered: September 27, 2004Reply With QuoteReport This Post


Picture of Leupold Man
posted Hide Post
Very nice!!!!!

Veteran and NRA Life Member
Posts: 2455 | Location: Waterloo Wisconsin | Registered: October 22, 2014Reply With QuoteReport This Post
  Powered by Social Strata  

© Specialty Pistols 2003 - 2019 All Rights Reserved.
All Material Contained Here Is Protected And May NOT Be Reproduced,
Copied or Distributed, in any form, Without Written Permission.
"Specialty Pistols", "Specialty Pistols Bulletin Board" and
"Specialty Pistol Gear" are Trademarks of
Accurate Arms & Ammo, LLC.