Specialty Pistols
scope ring height

This topic can be found at:
https://specialtypistols.infopop.cc/eve/forums/a/tpc/f/3826077864/m/8800047286

April 30, 2016, 10:44 PM
Coppertop2621
scope ring height
Hello ! Going to put a vortex pst FFP on my xp , I have a standard weaver style base , what 30 mm ring height should I use ? Thanks !!!! Jimmy
May 01, 2016, 12:04 AM
big10
I like high to x-high rings on my pistols, regardless of objective diameter. No cheek weld to be concerned with and a higher LOS to boreline optic parallel has it's advantages.

This message has been edited. Last edited by: big10,


thumbup Rod
------------------------------
It's not a break, it's a brake, unless it's a break, then it's broke ;-)
May 01, 2016, 12:21 AM
Iowa Fox
Each manufacturer will be a little different as to the measurement of their low, med, and high. If you go to the ring mfg website that you plan to use see if they have specs on their rings with measurements. I use Burris and they have specs for sure. Just divide your objective diameter by 2 and pick a ring height based on their numbers that will give sufficient clearance of the objective to the barrel. The Vortex website has real good specs on their scopes.
May 01, 2016, 10:53 AM
Coppertop2621
Thanks guys ! Iowa fox I didn't know that , done the math and I need high rings , thanks again guys !