Support Our Sponsors! Click On Their Banner To Visit Their Site!


Moderators: nmhunter
Go
New
Find
Notify
Tools
Reply
  
Muzzle Brake Login/Join 


072922



posted
Looking for advise, I have a xp 100 chambered in 450 Bushmaster. It has a Holland brake on it now. It just looks to large on pistol and it was not install properly by Jeremy England, its not in time. It also has trigger issue, so I was sending to Bayside for tune up. Figured I would put new brake on it while it was there. I've been told muzzle brakes on straight wall cartridges are not as effective, Threads are 3/4×24

Thanks. J.

 
Posts: 525 | Location: Illinois  | Registered: September 12, 2016Reply With QuoteReport This Post



Picture of Hoggin
posted Hide Post
A harrel will get you about as much recoil reduction on that as your going to get on a big bore.

Brake effectiveness increases as bore size goes down and gas increases.
 
Posts: 4009 | Location: Newcastle, WY | Registered: January 24, 2011Reply With QuoteReport This Post
  Powered by Social Strata  
 


© Specialty Pistols 2003 - 2021 All Rights Reserved.
All Material Contained Here Is Protected And May NOT Be Reproduced,
Copied or Distributed, in any form, Without Written Permission.
"Specialty Pistols", "Specialty Pistols Bulletin Board" and
"Specialty Pistol Gear" are Trademarks of
Accurate Arms & Ammo, LLC.