Specialty Pistols
Bolt release for XP100

This topic can be found at:
https://specialtypistols.infopop.cc/eve/forums/a/tpc/f/3826077864/m/6260012796

April 19, 2020, 07:57 AM
Jakealaka
Bolt release for XP100
Trying to find a shop or someone that does the Defiance style bolt release . Any suggestions on who to contact?
Thanks,
Jim W.
April 19, 2020, 11:56 AM
Rooterpig
Not sure what style mine is called but Chris at bayside did mine. There’s a little plunger that sticks down through stock that you push. Works great.

This message has been edited. Last edited by: Rooterpig,
April 19, 2020, 12:20 PM
BruceP
Chris at Bayside Custom Gunworks can do several different kinds including the Defiance I'm sure. I chose the plunger under the rear of the stock for mine too.

Bruce
April 20, 2020, 09:41 AM
Ernie
Plunger under the stock will be cheaper and works great


Ernie (xphunter) "The Un-Tactical"
WY-SHOT 2022 June 20-22
April 20, 2020, 02:48 PM
tgp
quote:
Plunger under the stock will be cheaper and works great


And with a little modification to the factory stop it actually will allow a longer OAL cartridge to be ejected.

Glenn


------------------------------
“Evil, unchecked, is the prelude to genocide. - Anonymous”
― Joel C. Rosenberg, The Auschwitz Escape


April 20, 2020, 06:09 PM
Jakealaka
Thanks I have the what I call the Sinclair bolt stop I believe that's considered the plunger.
April 20, 2020, 06:10 PM
Jakealaka
Thanks I have the what I call the Sinclair bolt stop I believe that's considered the plunger type.
April 20, 2020, 11:37 PM
Iowa Fox
Didn't Aaron have a few of those push buttons he was selling?

Jon
April 21, 2020, 08:21 AM
Jakealaka
Jon ,Anyway to contact I have found a few shops that do this release for 700's but they don't do XP's .I have a Sinclair type but I just had Jim Rockwell turn a piece of Claro walnut for a rear grip and I'm giving this action a new make over. Any insight would be appreciated.
Jim W
April 21, 2020, 03:41 PM
Iowa Fox
Jim,

I hope I wasn't misleading on my post. The push buttons Aaron had were the ones on the bottom of the stock not the ones that required a milled slot or hole in the left side of the receiver. Aarons didn't require and alteration to the receiver. Aarons email addy is in his profile, his screen name is rickiesrevenge. Don't be afraid to email him he;s a good guy.

Jon
April 21, 2020, 04:18 PM
Jakealaka
Jon ,
Thanks I'm looking for the one that you mill the receiver. I will try to contact him .
Thanks,
Jim W
April 21, 2020, 08:22 PM
rickiesrevenge
PTG sells a nosler/lawton style one that goes on the receiver. Looks a lot cleaner than the sinclair one. I like the one thats a button in the stock too. Cheap, clean, and super easy.

Aaron
April 21, 2020, 10:10 PM
Iowa Fox
Darn tinypic deleted the pics but here is a thread on making the push buttons.

Maybe freezwe will re
post the pics.

https://specialtypistols.infop...680074986#8680074986

Jon