Support Our Sponsors! Click On Their Banner To Visit Their Site!


Moderators: nmhunter
Go
New
Find
Notify
Tools
Reply
  
xp-100 center grip trigger screws. Login/Join 


103122



posted
Currently the trigger has a lot of take up and some creep. There is a set screw at the forward end of the trigger housing and a set screw at the forward end of the sear housing. Balance weight was previously removed. The trigger breaks good once you get to it.

What does each one of the screws adjust. I see no other adjustment screws.

Thanks


"The World Spins Forward"

 
Posts: 2744 | Location: lake of the ozarks, mo. | Registered: May 03, 2005Reply With QuoteReport This Post


103122



posted Hide Post
OK figured out the trigger housing screw. It was loose. Tightened it and that seems to have taken the take up out.

Red Loctite on the Sear housing screw. I think I will leave it alone until I do some safety checks and shoot it.


"The World Spins Forward"

 
Posts: 2744 | Location: lake of the ozarks, mo. | Registered: May 03, 2005Reply With QuoteReport This Post
  Powered by Social Strata  
 


© Specialty Pistols 2003 - 2021 All Rights Reserved.
All Material Contained Here Is Protected And May NOT Be Reproduced,
Copied or Distributed, in any form, Without Written Permission.
"Specialty Pistols", "Specialty Pistols Bulletin Board" and
"Specialty Pistol Gear" are Trademarks of
Accurate Arms & Ammo, LLC.