To fix mt Striker trigger, I'd like to modify a rifle stock to pistol config, take off the trigger, put in a dood trigger and put it all together. Does anyone know if any rifle stock will accept a striker action? I can cut away for the bolt on the left.
Look at the 7 fingers chassis
What's the measurement between the action screws?
xlr chassis makes one for the striker inlet as well. Dont have one but always thought if i got a striker it would get one.
I have not taken a caliper and measured all the holes and such, but the last time I did measure, I believe the holes in the Striker action are at 4.275", just like the earlier short actions. SO, you might be able to use any rifle stock made for the earlier Model 10, 11, and 12.
Of course, you could just start with a short action only and build up for a rear trigger.
Just a thought.
The action hole spacing is 4.362"/4.364" as close as I can measure it. Any actions with this spacing?
The 7finger chassis will fit the striker action. I have built four of these. There is even a drop mag version for the striker.This message has been edited. Last edited by: 7fingers,
|Powered by Social Strata|