Support Our Sponsors! Click On Their Banner To Visit Their Site!


Moderators: nmhunter
Go
New
Find
Notify
Tools
Reply
  
XP McMillan stock dimensions Login/Join 



posted
I have four planks of black walnut that have been air seasoned for seven years and I am considering turning them XP stocks. I currently do not own a XP that I can use for stock dimensions. If some will oblige me with width, hight, and length of McMillan mid grip and rear grip so can ascertain if the planks are thick enough.

Thank you in advance,
Pete


Peter Resetz
 
Posts: 147 | Location: Lapeer, MI. | Registered: September 02, 2017Reply With QuoteReport This Post



posted Hide Post
Length 16.00"
Height 5.25"
Width 1.72"
 
Posts: 17 | Location: NorthLeftCoast | Registered: March 20, 2020Reply With QuoteReport This Post



Picture of RICHP
posted Hide Post
The b.r. stock,s forearm is three inches wide, one and three quarters in. high. At the grip it is five and one half to six inches tall, one and three quarter inch wide. It is twenty one inches long.

Wish I was more computer savvy, I could help you more.


---------------
love those .41 mags.
 
Posts: 191 | Location: TEXAS | Registered: November 02, 2011Reply With QuoteReport This Post



posted Hide Post
Thank you both.

The planks of walnut are about 2-1/8” thick which I can plane one side flat.

Thanks again.


Peter Resetz
 
Posts: 147 | Location: Lapeer, MI. | Registered: September 02, 2017Reply With QuoteReport This Post
  Powered by Social Strata  
 


© Specialty Pistols 2003 - 2021 All Rights Reserved.
All Material Contained Here Is Protected And May NOT Be Reproduced,
Copied or Distributed, in any form, Without Written Permission.
"Specialty Pistols", "Specialty Pistols Bulletin Board" and
"Specialty Pistol Gear" are Trademarks of
Accurate Arms & Ammo, LLC.